Could not find a path when saving my translation in Editor

Question

Hi folks, I use SDL Trados Studio 2021 Freelance Plus SR2 - 16.2.9.9198. 
 When I save my translation with Ctrl+S, the below shown error message pops up from time to time: It is not always there: when I open Trados first, it works fine for an hour or two. Then, just out of sudden, the above message pops up. 
 I have compared the path before and after the error message appears. Before: And after: : Then I have to close Trados and re-open it again. Once Trados has started, the folder in question appears there again (as shown in the "Before" image) and the file saves well. What can be the culprit of this behavior? *I don't use any third-party antivirus software other than that built-in in Windows 10.

Oana Nagy · Accepted Answer

Stepan Konev We will be pleased to help you with this problem so have logged a support case on your behalf. You will be contacted at the email address used for this Community. Support Case Id : 00660620 .

Oana Nagy | Developer Experience | QA Engineer | RWS Group

Stepan Konev · Answer

To wrap up this issue: I was contacted by RWS support and their suggestions seem to have helped. Recently I installed a 6-day trial PROMT product and then simply forgot about it. It was several GB in size. And I noticed that my C drive bar turned red but didn't pay any attention to that event. Once I removed PROMT and released several GBs on my drive C, it turned blue again and the problem has gone.
Thank you Support!

Oana Nagy · Answer

Stepan Konev Have you tried this: https://gateway.rws.com/csm?id=kb_article_view&sysparm_article=KB0038682 
 Lyds

Trados Studio > 1. Trados Studio

Could not find a path when saving my translation in Editor

Top Replies