Fragment match does not show up

Question

I followed the setup instuctions found in signsandsymptomsoftranslation.com/2016/11/17/studio-2017-uplift/ but cannot see a fragmen match that in my opinion should be clearly available

Henk Sanderson · Answer

Finally found the solution: 
I needed fragment alignment for the TM to be set up. Strange enough, neither Paul Filkin ( in more-power-to-the-elbow-uplift) nor Emma Goldsmith in her article mentioned by Paul does refer to this need. 
Then SDL Online help: no matches (apart from useless entries in the glossary ) for "fragment match" or "fragment alignment". Finally I found the answer on a proz.com forum with instructions to prepare the TM. 
Now when this functionality is so heavily mentioned in the SDLadvertisements for Studio 2017, why has it not been made easier to set it up?

Paul · Answer

What do you mean by that Henk? Can you be specific what "fragment alignment for the TM to be set up" is for you?

Henk Sanderson · Answer

If you want to allow fragment match to work at all, it is indispensable to prepare the TM for that function. In online help, I have not found any information stating this requirement, nor any information on how to set it up. 
 How to set it up goes as follows: 
 Select Settings on the context menu of the TM to be prepared: 
 
 Select Fragment Alignment in the Settings menu: 
 
 Set Fragment Alignment Status On, then click Build Translation Model: 
 
 All options for continuing and refining the process are then explained in the Help, accessed from the button in the lower right of the screen. 
 
 I hope that the essential information on how to start this procedure as well as a hint to the requirement when you want to set up Fragment Match details will find their way into the Online Help.

Paul · Answer

That's what I thought you meant... it was mentioned in both my blog and Emmas! Probably neither of us went through it in the granular nature you have here (neither were intended to be a user manual :-)), but it was the first thing to do in both articles. 
 In the Studio help... I searched for Fragment Matching and then looked through the results, there are quite a lot, and opened the one that said Translation Memory Settings: 
 
 That explains the procedure, but I would agree that it's not very helpful. I can make sense of what to do because I know, but for someone looking for some basic guidance it's not particularly clear. Although I think once you get to the settings the process is pretty straightforward as you read the content: 
 
 Perhaps Cristina Nistor can take this back to TechPubs and refine the help a little... or show us where we should have been looking in the new help material.

Trados Studio > 2. Trados Studio

Fragment match does not show up